Enabling CDR Generation and Configuring the CDR Server Address

For the device to generate CDRs, you need to enable the syslog feature and configure a collecting server address. The collecting server can be a dedicated CDR server or the server used for syslog messages.

➢ To enable CDR generation and configure the CDR server address:
1. Enable the syslog feature (see Enabling Syslog).
2. Open the Call Detail Record Settings page (Troubleshoot menu > Troubleshoot tab > Call Detail Record folder > Call Detail Record Settings).
3. In the 'CDR Syslog Server IP Address' [CDRSyslogServerIP] field, enter the address (IPv4 or IPv6, or FQDN) of the server to where you want the CDRs sent.

4. Click Apply.
● If you don't configure an address for the CDR server, the device sends the CDRs to the address that you configured for the syslog servers in Configuring the Primary Syslog Server Address and Configuring Secondary Syslog Servers.
● The IP Interface, port configured for the syslog server in Configuring the Primary Syslog Server Address are also used for the CDR server.